Sony film imager, Instructions For Use Manual

2

Owner's Record

The model and serial numbers are located at the rear. 
Record these numbers in the space provided below.
Refer to these numbers whenever you call upon your 
Sony dealer regarding this product.

Model No. ____________________
Serial No. ____________________

To prevent fire or shock hazard, do not expose the unit to 
rain or moisture.

To avoid electrical shock, do not open the cabinet. Refer 
servicing to qualified personnel only.

THIS APPARATUS MUST BE EARTHED.

For the customers in the U.S.A.

This equipment has been tested and found to comply 
with the limits for a Class A digital device, pursuant to 
Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection again harmful 
interference when the equipment is operated in a 
commercial environment. This equipment generates, 
uses, and can radiate radio frequency energy and, if not 
installed and used in accordance with the instruction 
manual, may cause harmful interference to radio 
communications. Operation of this equipment in a 
residential area is likely to cause harmful interference in 
which case the user will be required to correct the 
interference at his own expense. 

You are cautioned that any changes or modifications not 
expressly approved in this manual could void your 
authority to operate this equipment.

This device requires shielded interface cables to comply 
with FCC emission limits.

For the customers in Canada

This unit has been certified according to Standard CSA 
C22.2 NO.601.1.

For the customers in the U.S.A and 
Canada

Model UP-DF500 is Non-Patient Equipment.
This unit can not be used in the vicinity of patients.

* Patient Vicinity

Important safeguards/notices for use in 
the medical environments

1. All the equipments connected to this unit shall be 

certified according to Standard IEC60601-1, 
IEC60950, IEC60065 or other IEC/ISO Standards 
applicable to the equipments.

2. When this unit is used together with other equipment 

in the patient area*, the equipment shall be either 
powered by an isolation transformer or connected via 
an additional protective earth terminal to system 
ground unless it is certified according to Standard 
IEC60601-1.

* Patient Area

3. The leakage current could increase when connected 

to other equipment.

4. This equipment generates, uses, and can radiate 

frequency energy. If it is not installed and used in 
accordance with the instruction manual, it may cause 
interference to other equipment. If this unit causes 
interference (which can be determined by 
unplugging the power cord from the unit), try these 
measures: Relocate the unit with respect to the 

WARNING

This symbol indicates the equipotential 
terminal which brings the various parts 
of a system to the same potential.

This symbol is intended to alert the user 
to the presence of important operating 
and maintenance (servicing) instructions 
in the literature accompanying the 
appliance.

R1.83m

(6 feet)

R1.5m