12
Changing the sound and
display settings
The following items can be set:
•CLOCK (page 6).
•BEEP – to turn the beep sound on or off.
•RM (Rotary Commander) – to change the
operative direction of the rotary commander.
— Select “NORM” to use the rotary
commander as the factory-set position.
— Select “REV” when you mount the rotary
commander on the right side of the
steering column.
•M.DSPL – to turn the Motion Display on or
off.
•A.SCRL (Auto Scroll)
*
(page 14).
1
Press
(SHIFT)
.
2
Press
(2)
(SET UP) repeatedly until the
desired item appears.
Each time you press
(2)
(SET UP), the item
changes as follows:
CLOCK
n
BEEP
n
RM
n
M.DSPL
n
A.SCRL
*
*
When no MD is playing, this item will not
appear (XR-C5120 only).
Note
The displayed item will differ depending on
the source.
3
Press
(4)
(
n
) to select the desired
setting (Example: ON or OFF).
4
Press
(SHIFT)
.
After the mode setting is complete, the
display returns to normal playback mode.
Note
If the “SFT” indication appears, press
(SHIFT)
to
complete the mode setting.
Adjusting the sound
characteristics
You can adjust the bass, treble, balance, and
fader.
You can store the bass and treble levels
independently for each source.
1
Select the item you want to adjust by
pressing
(SOUND)
repeatedly.
VOL (volume)
n
BAS (bass)
n
TRE (treble)
n
BAL (left-right)
n
FAD (front-rear)
2
Adjust the selected item by rotating the
dial.
Adjust within three seconds after selecting
the item. (After three seconds, the dial
function reverts to volume control.)
Attenuating the sound
Press
(ATT)
on the optional rotary
commander or wireless remote.
“ATT-ON” flashes momentarily.
To restore the previous volume level, press
(ATT)
again.
