Sony FWD-32B1 Operating Instructions Manual Download

Page: 48 / 289

WARNING

Owner’s Record

The model and serial numbers are located on the rear.
Record the model and serial numbers in the spaces
provided below. Refer to these numbers whenever you
call upon your Sony dealer regarding this product.

Model No.

Serial No.

To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or
moisture.

To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified
personnel only.

THIS APPARATUS MUST BE EARTHED.

On transportation

When you carry the display unit, hold the unit itself,
not the speakers. If you fail to do so, the speakers may
come out of the unit and the unit may fall. This can
cause injury.

WARNING

When installing the unit, incorporate a readily
accessible disconnect device in the fixed wiring, or
connect the power plug to an easily accessible socket-
outlet near the unit.
If a fault should occur during operation of the unit,
operate the disconnect device to switch the power
supply off, or disconnect the power plug.

For the customers in the U.S.A.

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
All interface cables used to connect peripherals must
be shielded in order to comply with the limits for a
digital device pursuant to Subpart B of Part 15 of FCC
Rules.

If you have any questions about this product, you may

call; Sony Customer Information Service Center
1-800-222-7669 or http://www.sony.com/

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.

WARNING:

THIS WARNING IS APPLICABLE FOR

USA ONLY.
If used in USA, use the UL LISTED power cord
specified below.
DO NOT USE ANY OTHER POWER CORD.

Plug Cap Parallel blade with ground pin

(NEMA 5-15P Configuration)

Cord

Type SJT or SVT, three 16 or 18 AWG
wires

Length

Minimum 1.5m (4 ft .11in.), Less than 2.5
m (8 ft. 3 in.)

Rating

Minimum 6A, 125V

Using this unit at a voltage other than 120V may
require the use of a different line cord or attachment
plug, or both.
To reduce the risk of fire or electric shock, refer
servicing to qualified service personnel.

Declaration of Conformity

Trade Name:

SONY

Model:

FWD-32B1

Responsible Party: Sony Electronics Inc.
Address:

16530 Via Esprillo, San
Diego, CA 92127 U.S.A.

Telephone Number: 858-942-2230

Declaration of Conformity

Trade Name:

SONY

Model: