26
Projecting
You will not be able to use the projector if you forget your password and the password
administrator is not available. Be please aware that using the security lock can prevent
valid usage in such cases.
1
Press the MENU key and then, in the INSTALL SETTING menu, turn on
the security lock setting.
2
Enter the password.
Use the MENU,
M
/
m
/
<
/
,
, and ENTER keys to enter the four-digit
password. (The default setting is
“
ENTER, ENTER, ENTER, ENTER.
”
)
Next, the screen for entering the new password is displayed. (Enter the
password at this screen even if you want to keep the current password.)
3
Enter the password again to confirm.
If “Invalid Password!” is displayed on the menu screen, perform again
from step 1.
4
Turn the main power off and disconnect the AC power cord.
The security lock is set to on, then it becomes effective. The screen for entering
the password is displayed when the power is turned on the next time.
Security certification
When the screen for entering the password is displayed, enter the password
that was set. If you fail to enter the correct password after three tries, the
projector cannot be used. In this case, press the
I
/
1
key to turn off the power.
To cancel the security lock
1
Press the MENU key, then turn off the “Security Lock” setting in the
INSTALL SETTING menu.
Note
Enter password key
Use:
Cancel: Other key
V Key s t o n e :
0
I m a g e F l i p :
O f f
B a ck g ro u n d : B l u e
L a m p M o d e :
S t a n d a rd
D i r e c t Pow e r O n : O f f
H i g h A l t i t u d e M o d e : O f f
S e c u r i t y L o ck :
O f f
INSTALL SETTING
Input A
I nva l i d Pa s swo rd !
X
