66
CCD-TR2300/TR3300 3-856-204-23 (1)
Notes on Date Search and Date Scan mode
• If a day’s recording is not longer than 2 minutes, the camcorder may not accurately
find its boundaries.
• Date Search and Date Scan do not function on a tape recorded by a camcorder
without the Data Code function. Your camcorder has the Data Code function.
• When searching the boundaries of date on the tape, the forwarded or reversed
picture appears in the viewfinder. Visual noise also appears during this searching.
This is not a mulfunction.
Searching the boundaries of recorded date
Returning to a pre-registered position
Using the Remote Commander, you can easily go back to the desired point on a tape
after playback. Use the tape counter. If the RC time code appears in the viewfinder, set
COUNTER to NORMAL in the menu system to display the tape counter.
(
1
)
During playback, press COUNTER RESET at the point you later want to locate.
The counter shows “0:00:00” in the viewfinder.
(
2
)
Press
π
when you want to stop playback.
(
3
)
Press ZERO MEM on the Remote Commander. The ZERO MEM indicator
flashes in the viewfinder.
(
4
)
Press
0
to rewind or press
)
to fast-forward the tape to the counter’s zero
point. The tape stops automatically when the counter reaches approximately zero.
REW
3
0
0:00:00
3
1
4
2
0:12:34
ZERO MEM
STOP
ZERO MEM
COUNTER RESET
Notes on the tape counter
• Something must be recorded on the tape in order for the tape counter to function.
Tape counter does not work on a blank tape.
• There may be a discrepancy of several seconds from the actual time.
Notes on ZERO MEM
• When you press ZERO MEM, the counter’s zero point is memorized. Press ZERO
MEM again before rewinding to cancel the memory.
• This function is cancelled automatically once the tape is rewound or advanced to the
point you pre-registered.
• ZERO MEM does not function during recording or playing back.
