110
Various messages appear on the screen. Check the corresponding descriptions in the
following list.
General
Message
Cause and/or Corrective Actions
Bluetooth Connection Error
Bluetooth
Authentication Error
Check the Certified Status
Bluetooth
Registration Error
Check the Passkey
Bluetooth Communication
Disconnected
Bluetooth
Connection Error
Select Bluetooth Device
PPP Authentication Error
Check ID or Password
Phone Line Disconnected
Connection Error
No Response From PPP Server
Connection Error
Check Phone Line
Low Battery
Profile Error
Reset Profile
DI Customer ID Profile
Incompleted
Memory Error
Password Already Set
Check the Password
Profile
Memory Stick Error
Memory Stick Error
Outgoing Mail Canceled
Memory Stick Error
Unable to Open the File
Memory Stick Error
Action Canceled
Memory Stick Error
Incoming Mail Canceled
Messages
• The Bluetooth device is too far from your camcorder.
• The Bluetooth device is busy.
Register the Bluetooth device again.
• The pass key was wrong.
• The pass key transmission failed.
• The Bluetooth device was turned off.
• The Bluetooth device is too far from your camcorder.
• The Bluetooth device became impossible to connect.
No Bluetooth devices are registered. Register the Bluetooth device
(p. 19).
Your ID or password entered on the PPP screen during manual
setup may be wrong (p. 46).
Check the connection status.
• The telephone number entered on the PPP screen in manual setup
may be wrong.
• The setup of Modem unit on the Network Options screen is wrong.
Check that the Bluetooth device is connected to a telephone terminal.
The capacity of the battery pack is insufficient. Change the battery
pack or use the AC power adaptor.
Check the setup. If an entry is missing, set up again referring to your
notes.
Check your DI customer ID or password entered on the Network
Setup screen.
Exit the NETWORK mode, then enter the NETWORK mode again.
For details on “Verify Password”, see “Setting other preferences”
(p. 49).
The “Memory Stick” may be broken. Do the following; exit the
NETWORK mode, turn off the camcorder, remove and insert the
“Memory Stick,” then operate the camcorder. If the message still
appears, use another “Memory Stick.”