Troubleshooting
83
Warning indicators and messages
Self-diagnosis display/Warning
indicators
If indicators appear on the LCD screen,
check the following.
If the problem persists even after you have
tried a couple of times, contact your Sony
dealer or local authorized Sony service
facility.
C:04:00
C:(or E:)
:
(Self-diagnosis
display)
C:04:
The battery pack is not an “InfoLITHIUM”
battery pack (H series). Use an
“InfoLITHIUM” battery pack (H series)
(p. 91).
Connect the DC plug of the AC Adaptor to
the DC IN jack of the Handycam Station
(DCR-SR65/SR85) or your camcorder
securely (p. 13).
C:13:
/ C:32:
Remove the power source. Reconnect it
and operate your camcorder again.
Turn on your camcorder again.
E:20:
/ E:31:
/ E:61:
/
E:62:
/ E:91:
/ E:94:
A malfunction that you cannot service has
occurred. Contact your Sony dealer or local
authorized Sony service facility. Inform
them of the 5-digit code, which starts from
“E.”
101-0001 (Warning indicator
pertaining to files)
Slow flashing
The file is damaged.
The file is unreadable.
(Warning on the hard disk of the
camcorder)
*
Fast flashing
An error may have occurred with the hard
disk drive in your camcorder.
(Warning on the hard disk of the
camcorder)
*
Fast flashing
The hard disk of the camcorder is fully
recorded.
An error may have occurred with the hard
disk drive in your camcorder.
(Battery level warning)
Slow flashing
The battery pack is nearly used up.
Depending on the operating environment
or battery conditions,
may flash, even
if there are approximately 20 minutes
remaining.
(High temperature warning)
Slow flashing
The temperature of your camcorder is
getting higher. Turn off your camcorder
and leave it for a while in a cool place.
Fast flashing
*
The temperature of your camcorder is
extremely high. Turn off your camcorder
and leave it for a while in a cool place.
(Low temperature warning)
*
Fast flashing
The temperature of your camcorder is
extremely low. Make the camcorder warm.
Summary of Contents for Handycam DCR-SR46
Page 108: ......