GB
On Wireless Remote Commander
Remove the insulation sheet before using the
Wireless Remote Commander.
Point the Wireless Remote Commander
towards the remote sensor to operate your
camcorder (p. 11).
When no commands have been sent from the
Wireless Remote Commander within a certain
period, the light blue frame disappears. When
you press any of
/
/
/
, or ENTER again,
the frame appears at the position where it was
displayed last.
You cannot select some buttons on the LCD
screen, or the viewfinder (HDR-CX730E/
CX740VE/CX760E/CX760VE/PJ740VE/
PJ760E/PJ760VE) using
/
/
/
.
To change the battery of the Wireless Remote
Commander
While pressing on the tab, inset your fingernail
into the slit to pull out the battery case.
Place a new battery with the + side facing up.
Insert the battery case back into the Wireless
Remote Commander until it clicks.
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
When the lithium battery becomes weak, the
operating distance of the Wireless Remote
Commander may shorten, or the Wireless
Remote Commander may not function
properly. In this case, replace the battery with
a Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.
LCD screen
Do not apply excessive pressure on the LCD
screen, as it may cause uneven color and other
damage.
If your camcorder is used in a cold place, a
residual image may appear on the LCD screen.
This is not a malfunction.
While using your camcorder, the back of
the LCD screen may heat up. This is not a
malfunction.
To clean the projector lens (HDR-
PJ710VE/PJ720E/PJ740VE/PJ760E/
PJ760VE)
Wipe the lens gently with a soft cloth such as a
cleaning cloth or glass cleaning cloth.
Stubborn stains may be removed with a soft
cloth such as a cleaning cloth or glass cleaning
cloth lightly dampened with water.
Never use a solvent such as alcohol, benzene or
thinner; acid, alkaline or abrasive detergent; or
a chemical cleaning cloth, as they will damage
the lens surface.
On adjustment of the touch panel
([Calibration])
The buttons on the touch panel may not
work correctly. If this happens, follow the
procedure below. It is recommended that
you connect your camcorder to the wall
outlet (wall socket) using the supplied AC
Adaptor during the operation.
[Setup]
[
General Settings]
[Calibration].
Insulation sheet
Tab
Summary of Contents for Handycam HDR-CX730E
Page 95: ...95 GB Others Index ...