GB
To adjust the angle of the LCD panel
First open the LCD panel 90 degrees to the
camcorder (
), and then adjust the angle
(
).
To turn off the beep sound
Select
[Setup]
[
General Settings]
[
Beep
]
[Off].
Notes
The recording date and time are recorded automatically on the recording media. They are not displayed
during recording. However, you can check them as [Data Code] during playback. To display them, select
[Setup]
[
Playback Settings]
[Data Code]
[Date/Time].
Once the clock is set, the clock time is automatically adjusted with [Auto Clock ADJ ] and [Auto Area
ADJ] set to [On]. The clock may not automatically adjust to the correct time, depending on the country/
region selected for your camcorder. In this case, set [Auto Clock ADJ ] and [Auto Area ADJ] to [Off]
(models with GPS).
To set the date and time again: [Date & Time Setting] (p. 54)
To calibrate the touch panel: [Calibration] (p. 54)
90 degrees (max.)
180 degrees (max.)
90 degrees to the camcorder
