81
Cus
to
m
iz
ing yo
ur ca
m
co
rder
ONE PUSH (
)
The white balance will be adjusted
according to the ambient light.
1
Touch [ONE PUSH].
2
Frame a white object such as a piece of
paper, to fill the screen under the same
lighting conditions as you will shoot
the subject.
3
Touch [
].
flashes quickly. When the white
balance has been adjusted and stored in
the memory, the indicator stops
flashing.
•Keep framing a white object while
is flashing quickly.
•
flashes slowly if white balance
could not be set.
•If
keeps flashing even after you
have touched
, set [WHITE BAL.] to
[AUTO].
• If you changed the battery pack, or moved your
camcorder to or from outdoors when [AUTO]
was selected, aim your camcorder at a nearby
white object with [AUTO] for about 10 seconds
for better color balance adjustment.
• Redo the [ONE PUSH] procedure if you change
the [PROGRAM AE] settings, or bring your
camcorder outdoors from inside the house, or
vice versa.
• Set [WHITE BAL.] to [AUTO] or adjust the
color in [ONE PUSH] under white or cool white
fluorescent lamps.
• The setting returns to [AUTO] when you set the
POWER switch to OFF (CHG) for more than 12
hours.
When you set [COLOR SLOW S] to [ON],
you can record an image brighter in color
even in dark places.
appears on the screen.
To cancel [COLOR SLOW S], touch
[OFF].
• Adjust the focus manually ([FOCUS], p. 78)
when it is hard to focus automatically.
• The shutter speed of your camcorder changes
depending on the brightness, which may result
in a slowdown of the motion of the image.
The image will be recorded at a maximum
of 16 times the sensitivity of NightShot
recording if you set [SUPER NS] to [ON]
while the NIGHTSHOT switch (p. 37) is
also set to ON.
appears on the screen.
To return to the normal setting, set [SUPER
NS] to [OFF].
• Do not use [SUPER NS] in bright places. This
may cause a malfunction.
• Do not cover the infrared port with your fingers
or other objects (p. 37).
• Remove the conversion lens (optional).
• Adjust the focus manually ([FOCUS], p. 78)
when it is hard to focus automatically.
• The shutter speed of your camcorder changes
depending on the brightness, which may result
in a slowdown of the motion of the image.
You can record a transition with the
following effects adding to the interval
between scenes.
1
Select the desired effect in [STBY] (during
fading in) or [REC] (during fading out)
mode, then touch
.
2
Press START/STOP.
The fader indicator stops flashing and
disappears when the fade is complete.
To cancel the fader before starting the
operation, touch [OFF] in step
1
.
If you press START/STOP, the setting is
canceled.
COLOR SLOW S (Color
Slow Shutter)
SUPER NS (Super
NightShot)
FADER
STBY
REC
Fading out
Fading in
Continued
,
