10
Getting started
Step 1: Charging the battery pack
You can charge the “InfoLITHIUM” battery pack (H series) after attaching it to your
camcorder.
You cannot attach any “InfoLITHIUM” battery pack other than the H series to your camcorder.
1
Turn off your camcorder by closing the LCD screen.
2
Attach the battery pack by sliding it in the direction of the arrow until it
clicks.
3
Connect the AC Adaptor and the power cord (mains lead) to your
camcorder and the wall outlet (wall socket).
Be sure that the
mark on the DC plug is facing the right.
The charge lamp lights up and charging starts. The charge lamp turns off when the
battery pack is fully charged.
4
When the battery is charged, disconnect the AC Adaptor from the DC IN
jack of your camcorder.
See page 55 on charging, recording and playing time.
When your camcorder is on, you can check the approximate amount of remaining battery power with the
remaining battery indicator at the upper left on the LCD screen.
Battery pack
DC IN jack
DC plug
AC Adaptor
Power cord (mains lead)
ACCESS lamp
(hard disk)
Charge lamp
To the wall outlet (wall socket)
Summary of Contents for Handycam HDR-XR100E
Page 63: ...63 ...