HAP-Z1ES
31
4-8. Ether
Procedure:
1. Connect the main unit to the router with the network LAN
cable.
2. Enter the service DIAG mode.
(Refer to “1. Entering Method of The Service DIAG Mode” on
page 25)
3. Rotate the selector knob to select the “8. Ether”.
4. Press the [ENTER] key to enter the “8. Ether” mode.
8.Ether
1. Network Info
2. Ping
3. Back to Main Menu
4-8-1. Network
Info
It can display the wired network information.
Procedure:
1. Enter the “8. Ether” mode.
(Refer to “4-8. Ether”)
2. Rotate the selector knob to select the “1. Network Info”.
3. Press the [ENTER] key to enter the “1. Network Info” mode.
Note:
“1. IP Address”, “2. Subnet Mask” and “3. Default Gateway” sup-
ports only DHCP.
8-1.Network Info
1. IP Address
2. Subnet Mask
3. Default Gateway
4. Linkup Speed
5. Back to Main Menu
172.17.100.26
255.255.0.0
172.17.0.200
1Gbps
(Displayed characters/values in the above
fi
gure are example)
4-8-2. Ping
It can display the results indicating whether or not the gateway
responded to the PING.
Note:
This mode supports only DHCP.
Procedure:
1. Enter the “8. Ether” mode.
(Refer to “4-8. Ether”)
2. Rotate the selector knob to select the “2. Ping”.
3. Press the [ENTER] key to enter the “2. Ping” mode.
4. The results indicating whether or not the gateway responded to
the PING is displayed on the liquid crystal display.
(When the gateway does not respond to the PING, “Error!!
Can’t get gateway-ip” is displayed on the liquid crystal dis-
play)
8-2.Ping
ping to 172.17.0.200 : OK
Back to Ether Menu
(Displayed characters/values in the above
fi
gure are example)
Summary of Contents for HAP-Z1ES
Page 119: ...MEMO HAP Z1ES 119 ...