Sony HCD-AZ2D Service Manual Download

Page: 5 / 110

HCD-AZ2D/AZ5D

The laser diode in the optical pick-up block may suffer electrostatic
break-down because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.

NOTES ON LASER DIODE EMISSION CHECK

The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.

UNLEADED SOLDER

Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with

the lead free mark due to their particular size)

: LEAD FREE MARK

Unleaded solder has the following characteristics.

•

Unleaded solder melts at a temperature about 40 ˚C higher

than ordinary solder.

Ordinary soldering irons can be used but the iron tip has to be

applied to the solder joint for a slightly longer time.

Soldering irons using a temperature regulator should be set to

about 350 ˚C.
Caution: The printed pattern (copper foil) may peel away if

the heated tip is applied for too long, so be careful!

•

Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)

than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.

•

Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may

also be added to ordinary solder.

RELEASING THE DISC SLOT LOCK

The disc slot lock function for the antitheft of an demonstration
disc in the store is equipped.

Releasing Procedure:

1. Press

`/1

button to turn the power on.

2. Touch the

[DVD]

sensor to select the “DVD”.

3. Touch the

sensor and press the

button simultaneously

and hold down until “UNLOCKED” displayed on the
fluorescent indicator tube (around 5 seconds).

Note:

When “LOCKED” is displayed, the slot lock is not released by turning
power on/off with the

`/1

button.

NOTE OF REPLACEMENT THE DMB10 BOARD

New part of EEPROM (IC103) on the DMB10 board can not be
used. Therefore, if the mounted DMB10 board is replaced, exchange
new EEPROM with that used before the replacement.

NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT

SECTION 1

SERVICING NOTES

MODEL IDENTIFICATION
– Back Panel –

•

Abbreviation
AUS : Australian model
E2

: 120V AC area in E model

: 240V AC area in E model

E12 : 220-240V AC area in E model
E13 : 220-230V AC area in E model (Russian model)
E15 : Iranian model
EA : Saudi Arabia model
KR : Korean model
MY : Malaysia model
PH : Philippines model
SP

: Singapore model

TH : Thai model

PART No.

Model

PART No.

HCD-AZ2D: SP, MY

2-349-677-0

[]

HCD-AZ2D: E2

2-349-677-1

[]

HCD-AZ2D: E12, E13