35
HCD-C5
6-4. Auto Check
(See page 38)
YES
NO
NO
NO
NO
NO
NO
NO
YES
YES
YES
YES
YES
YES
Replace IC195
Replace OP or IC195
Replace IC101, IC195, or D101
11. Iop NV SAVE (See page 41)
Replace OP, IC190, or IC195
Replace OP, IC102, IC190,
or IC195
Replace OP, IC101, IC151,
or IC195
Replace OP
After turning off and then on the power,
initialize the EEPROM
For details, refer to “WHEN MEMORY NG IS DIS-
PLAYED” in Section 4. TEST MODE (See page 29)
• Abbreviation
OP: optical pick-up
7. INITIAL SETTING OF ADJUSTMENT VALUE
(See page 40)
9. TEMPERATURE COMPENSATION OFFSET
ADJUSTMENT (See page 40)
10. LASER POWER ADJUSTMENT (See page 40)
12. TRAVERSE ADJUSTMENT (See page 41)
13. FOCUS BIAS ADJUSTMENT (See page 43)
16. AUTO GAIN CONTROL OUTPUT LEVEL
ADJUSTMENT (See page 44)
8. RECORDING AND DISPLAYING THE IOP
INFORMATION (See page 40)
End adjustments
Start
Adjustment flow
