4
HCD-EP707
Ver 1.1
NOTE FOR TRANSPORTING A SET
After repair is completed, be sure to attach EP707 (SAFETY)
(STRIP) (Part No. 4-244-664-01) and EP707 (STUD) (Part No. 4-
244-665-01) on the set with following procedure before you trans-
port a set.
1
Re-tie the strip on the disc tray as shown (see Fig.
A
).
2
Press
?
/
1
to close the disc tray.
The system turns off. Do not press DISC 1 - 3 or
Z
to close the disc
tray.
3
Reinsert the tagged pin (see Fig.
B
).
A
B
EP707 (SAFETY) (STRIP)
(Part No. 4-244-664-01)
EP707 (STUD)
(Part No. 4-244-665-01)
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
SECTION 1
SERVICING NOTES
• MODEL IDENTIFICATION
– Rear View –
Power Voltage
Indication
AC: 120 V 60 Hz 38 W
AC: 230 V
-
50/60 Hz 38 W
Model
US and Canadian
models
Other models
Power Voltage Indication
