Tape player section
Recording system
4-track 2-channel stereo
Frequency response
40-13,000 Hz (±3 dB), using
SONY TYPE I cassette
40-14,000 Hz (±3 dB), using
SONY TYPE II cassette
Wow and flutter
± 0.15% W.Peak (IEC)
0.1% W.RMS (NAB)
± 0.2% W.Peak (DIN)
Amplifier section
Peak music power output:
1,400 W (6 a t 1 kHz, 10% THD)
Continuous RMS power output:
FRONT SPEAKER
45 W + 45 W (6 ohms, at 1 kHz, 5% THD)
SUPER WOOFER
45 W + 45 W (6 ohms, 5% THD)
SURROUND CENTER SPEAKER
40 W (8 ohms, at 1kHz 5% THD)
SURROUND REAR SPEAKER
20 W + 20 W (16 ohms, at 1 kHz, 5% THD)
Inputs
PHONO (phono jack):
Sensitivity 3 mV, impedance 47 kilohms
LD/VIDEO (AUDIO) (phono jack):
Sensitivity 250 mV, impedance 47 kilohms
MIC (phone jack):
Sensitivity 1 mV, impedance 10 kilohms
Outputs
PHONES (phone jack):
accept headphones of 6 to 16 ohms
FRONT SPEAKER: accept impedance of 6 to 16 ohms
SURROUND SPEAKER CENTER:
accept impedance of 8 to 16 ohms
SURROUND SPEAKER REAR:
accept impedance of 16 ohms
SUPER WOOFER:
accept impedance of 6 to 16 ohms
110-120 V or 220-240 V AC
adjustable, 50/60 Hz
Approx. 355 x 425 x 400 mm (w/h/d)
incl. projecting parts and controls
Mass
Approx. 13 kg
Design and specifications subject to change without notice.
Laser component in this product is capable of emitting radiation
exceeding the limit for Class 1.
This appliance is classified as a
CLASS 1 LASER product.
The CLASS 1 LASER PRODUCT
MARKING is located on the rear
exterior.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
CAUTION
Use of controls or adjustments or performance of
procedures other than those specified herein may result in
hazardous radiation exposure.
This caution label
is located inside
the unit.
SAFETY-RELATED COMPONENT WARNING !!
COMPONENTS IDENTIFIED BY MARK
!
OR DOTTED LINE
WITH MARK
!
ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
