4
HCD-RV2/RV5/RV6
[MC Test Mode]
• This mode is used to check operations of the respective sections
of Amplifier, Tuner, and Tape.
Procedure:
• To enter MC Test Mode
1. Press
?
/
1
button to turn on the set.
2. Press the three buttons of
x
, GAME EQ and DISC 3 simul-
taneously.
* Check of Amplifier
Initial settings: Input
,
GAME
EQ
,
FLAT
Mode
,
MUSIC
VA CS
,
OFF
Output channel switching:
MUSIC key: L
,
L
R
,
R through
MOVIE key: L
,
SL
R
,
SR through
GAME key:L
,
L, SL, C
R
,
R, SR, SW through
1. When VOLUME control knob is turned clockwise even slightly,
the sound volume increases to is maximum and a message “VOL-
UME MAX” appears for two seconds, then the display returns
to the original display.
2. When VOLUME control knob is tuned counter-clockwise
even slightly, the sound volume decreases to its minimum and a
message “VOLUME MIN” appears for two seconds, then the
display returns to the original display.
3. When you press the
v
button, the message “GEQ MAX” is
displayed and the entire band of the graphic equalizer is set to
the maximum level.
4. When you press the
V
button, the message “GEQ MIN” is
displayed and the entire band of the graphic equalizer is set to
the minimum level.
5. When you press the
b
,
B
or P FILE (HCD-RV5/RV6),
EFFECT ON/OFF (HCD-RV2) button, the message “GEQ FLT”
is displayed and the entire band of the graphic equalizer is set to
the center level.
6. Whenever you press the ENTER (HCD-RV5/RV6), GROOVE
(HCD-RV2) button, it toggles between “VACS ON” and “VAC
OFF” so that you can switch ON or OFF of VACS.
* To return to normal mode again.
1. When you want to exit this mode, press
?
/
1
button.
2. The cold reset is enforced at the same time.
[Aging Mode]
This mode can for operation check of tape deck section.
• If an error occurred:
The aging operation stops and display then status.
• If no error occurs:
The aging operation continues repeatedly.
Procedure:
1. Press the CD button to select the function “CD”.
2. Load the tapes into the decks A and B respectively.
3. Set a disk in “DISK1” tray.
4. Press the PLAY MODE button to set the “ALL DISCS” mode,
and press the REPEAT button to “REPEAT” off.
5. Press three buttons of
x
, GAME EQ , and DISC SKIP/EX-
CHANGE simultaneously.
6. The florescent indicator tube display “AGING”, aging mode start.
7. To exit from the aging mode, operate the cold reset.
• The sequence during the aging mode is following as below.
• If an error occurred, stop display that step.
Aging mode sequence (Tape deck section):
Rewind the tape A
“TAPE A AG-1”
Rewind the tape B
“TAPE A AG-2”
FWD play the tape A
“TAPE A AG-3”
Fast forward the tape A
“TAPE A AG-4”
RVS play the tape A
“TAPE A AG-5”
Rewind the tape A
“TAPE A AG-6”
FWD play the tape B
“TAPE B AG-3”
Fast forward the tape B
“TAPE B AG-4”
RVS play the tape B
“TAPE B AG-5”
Rewind the tape B
“TAPE B AG-6”
Shut off
Shut off
2 minutes
Shut off or 20 seconds
2 minutes
Shut off
2 minutes
Shut off or 20 seconds
2 minutes
Shut off
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
