Sony HCD-SHAKE33, Operating Instructions Manual

model name [SHAKE-99/SHAKE-77/SHAKE-55/SHAKE-33]

[4-487-569-

14

(1)] GB

40

GB

filename[D:\NORM'S JOB\SONY HA\SO140043\SHAKE-99_77_55_33 (PMRF 
04)\4487569141_GB\080ADD.fm]

masterpage:Left

Playback does not start from the first 
file.

• Set the play mode to Normal Play 

(page 18).

Audio file cannot be played back.

• USB devices formatted with file 

systems other than FAT16 or FAT32 are 
unsupported.*

• A WMA audio file that is the WMA 

DRM, WMA Lossless, or WMA PRO 
format cannot be played back.

• An AAC audio file that is the AAC 

DRM or AAC Lossless format cannot 
be played back.

• AAC audio files encoded at 96 kHz 

cannot be played back.

• If multiple partitions exist on a USB 

device that is being used, files may not 
be played back.

• The system can play back to a depth of 

8 folders only.

• Files that are encrypted or protected by 

passwords cannot be played back.

• Files with DRM (Digital Rights 

Management) copyright protection 
cannot be played back by this system. 

• The MP3 PRO audio file can be played 

back as MP3 audio file.

* This system supports FAT16 and FAT32, but 

some USB devices may not support all of 
these FAT. For details, refer to the operating 
instructions of each USB device or contact the 
manufacturer.

Tuner

There is severe hum or noise, or 
stations cannot be received. 
(“TUNED” or “ST” flashes in the 
display panel.)

• Connect the antenna properly.
• Change the antenna location and its 

orientation to obtain good reception.

• Connect a commercially available 

external antenna.

• Consult your nearest Sony dealer if the 

supplied AM antenna has come off from 
the plastic stand.

• Turn off surrounding electrical 

equipment.

Bluetooth

 device

Pairing cannot be performed.

• Move the 

Bluetooth

 device closer to the 

system.

• Pairing may not be possible if other 

Bluetooth

 devices are present around the 

system. In this case, turn off the other 

Bluetooth

 devices.

• Make sure the correct passkey was 

entered at the 

Bluetooth

 device.

The 

Bluetooth

 device cannot detect 

this unit, or “BT OFF” appears in the 
display panel.

• Set the 

Bluetooth

 signal to “BT ON” 

(page 28).

Connection is not possible.

• The 

Bluetooth

 device you attempted to 

connect does not support the A2DP 
profile, and cannot be connected with 
the system.

• Enable the 

Bluetooth

 function of the 

Bluetooth

 device.

• Establish a connection from the 

Bluetooth

 device.

• The pairing registration information has 

been erased. Perform the pairing 
operation again.

• Erase the pairing registration 

information of the 

Bluetooth

 device 

(page 28) and perform the pairing 
operation again (page 26).

The sound skips or fluctuates, or the 
connection is lost.

• The system and the 

Bluetooth

 device are 

too far apart.

• If there are obstacles between the 

system and your 

Bluetooth

 device, 

remove or avoid the obstacles.