7
HCD-TB20
Setting the clock
1
Turn on the system.
2
Press CLOCK/TIMER SET on the
remote.
3
Press
.
or
>
on the remote to set
the hour.
4
Press ENTER/YES.
The minute indication flashes.
5
Press
.
or
>
on the remote to set
the minute.
6
Press ENTER/YES.
The clock starts working.
If you make a mistake
Press
m
or
M
on the remote repeatedly
until the incorrect item flashes, then set it
again.
To adjust the clock
1
Press CLOCK/TIMER SET on the remote.
2
Press
.
or
>
on the remote to select
“CLOCK SET?”, then press ENTER/YES.
3
Do the same procedures as step 3 to 6
above.
Note
You cannot set the clock in the Power Saving Mode.
When you play
a CD single (8
cm CD), place
it on the inner
circle of the
tray.
Loading a CD
1
Press DISC 1 – 3
Z
.
The disc tray opens.
2
Place a CD with the label side up on the
disc tray.
To load other CDs, press a different
Z
and
place the CD in the disc tray.
3
Press the same
Z
again to close the
disc tray.
Summary of Contents for hcd-tb20
