54
Locations and Functions of Parts
c
SC PHASE (subcarrier phase) switch
Used to adjust the SC phase with respect to the reference
signal (black burst).
This switch will return its original position when you
release it. Press and hold the switch towards ADV to
advance the phase or towards DELAY for delay.
VDA-A Board
a
VBS 1, VBS 2 (composite video output 1, 2)
connectors (BNC-type)
The signal from the video camera may be output as two
analog composite signals.
b
PIX OUT (picture monitor output) connector
(BNC-type)
Outputs the video signal for a picture monitor selected
with the PICTURE MONITOR button of an RCP-700
series Remote Control Panel or MSU-900 series Master
Setup Unit. Character signals or marker signals can be
superimposed on the video signal output through this
connector.
For details on these operations, refer to the Master Setup
Unit or Remote Control Panel manuals.
c
WF OUT (waveform monitor output) connector
(BNC-type)
Outputs the video signal for a waveform monitor selected
with the WF MONITOR button of an RCP-700 series
Remote Control Panel or MSU-900 series Master Setup
Unit.
For details on these operations, refer to the Master Setup
Unit or Remote Control Panel manuals.
VDA-B Board
a
FRAME REF IN/OUT (frame reference input/
output) connectors (BNC-type)
Input an HD tri-level reference sync signal or SD reference
sync signal (black burst signal) for the sequence-lock
between the camera control units, to the upper of the two
connectors.
The input signal is output from the lower connector as is
(loop-through output).
b
PIX OUT (picture monitor output) connector
(BNC-type)
Outputs the video signal for a picture monitor selected
with the PICTURE MONITOR button of an RCP-700
series Remote Control Panel or MSU-900 series Master
Setup Unit. Character signals or marker signals can be
superimposed on the video signal output through this
connector.
For details on these operations, refer to the Master Setup
Unit or Remote Control Panel manuals.
c
WF OUT (waveform monitor) connector (BNC-
type)
Outputs the video signal for a waveform monitor selected
with the WF MONITOR button of an RCP-700 series
Remote Control Panel or MSU-900 series Master Setup
Unit.
For details on these operations, refer to the Master Setup
Unit or Remote Control Panel manuals.
VDA-A
1
2
PIX
OUT
WF
OUT
VBS
1
VBS 1, VBS 2 connectors
2
PIX OUT connector
3
WF OUT connector
FRAME
REF IN
PIX
OUT
WF
OUT
OUT
VDA-B
1
FRAME REF IN/OUT connectors
2
PIX OUT connector
3
WF OUT connector
