.
IM/HDCU1000 Series
1-35 (E)
c
.
Mount the unit by two persons or more.
A one-man job may cause injury.
.
If you forget to fasten the screws of the rack angle, the
unit may slip and fall, causing injury.
After rack mounting, be sure to fasten the screws.
.
Be careful not to get your finger or hand caught in rack
mount rail. Injury could occur by drop of the unit in
unbalance condition of installation or removal. Install in
a posture of stability and carefully.
5.
While pressing the stoppers of the inner rails, slide the
inner rails fully into the outer rails, and push the unit
into the rack slowly.
6.
After confirming that the unit can be moved smoothly,
tighten the screws (B5
x
8) secured temporarily in the
step 4.
n
When securing the front brackets to the rack by screws,
pull the unit out of the rack about 20 cm (8 inches), and
fasten the screws of the front brackets to the rack.
7.
After installing the unit in the rack, fix the unit to the
rack using the four screws (RK5
x
14) and four
ornamental washers.
Rack
Outer rail
Inner rail
Stopper
Ornamental washer
RK5
x
14
Ornamental
washer
RK5
x
14
Rack
