23
Preparatory Settings
For settings regarding the format, refer to the operation
manual supplied with the CCU.
When an HDFA-200 is used as a standalone
device
The output format is set with an HDFA-200.
Set the format on the OUTPUT FORMAT (M06) page of the
MAINTENANCE menu.
The format for the cameras connected to the HDFA-200 is
automatically set to the settings on the HDFA-200. However,
for a camera such as an F35 that does not support the camera
format command, set the format to the same one as for the
HDFA-200, using the menu of the camera.
Setting the Picture Inverting Function
for a Rig
In 3D mode, pictures from the left and right cameras can be
inverted vertically or horizontally to suit the 3D rig to which
cameras are mounted. For a camera without the picture
inverting function, pictures are inverted with the circuit in the
HDFA-200. For a camera that has the picture inverting function
such as an HDC-P1, the camera’s inverting function is
controlled with commands. When inverting pictures, delay of
the left and right camera’s signals is automatically adjusted to
match the timing.
Select an appropriate number from 1 to 12 for RIG on the
IMAGE INVERTER (M10) page of the MAINTENANCE menu
while monitoring pictures on the viewfinder screen.
For details, see <IMAGE INVERTER> (page 32) of the
MAINTENANCE menu.
