4
Notes About the
Discs
• To keep the disc clean, handle the disc by
its edge. Do not touch the surface.
• Do not expose disc to direct sunlight or
heat sources such as hot air ducts, or leave
it in a car parked in direct sunlight as the
temperature may rise considerably inside
the car.
• After playing, store the disc in its case.
• Clean the disc with a cleaning cloth.
Wipe the disc from the center out.
• Do not use solvents such as benzine,
thinner, commercially available disc/lens
cleaners, or anti-static spray intended for
vinyl LPs.
• If you have printed the disc’s label, dry the
label before playing.
Precautions
Usage and storage
• Only use the specified power cord.
• Never short-circuit any of the connectors
with a metallic object such as a keyholder.
• Do not leave the unit in locations where
the temperature may rise above 60°C
(140°F), such as in direct sunlight.
• Protect the unit from water and moisture.
• Use the unit on a flat level surface.
• Do not install this equipment in a confined
space such as a bookshelf or similar unit.
• To prevent fire or shock hazard, do not
place objects filled with liquids, such as
vases, on the apparatus.
• Turn off the unit before carrying it.
• Do not touch the memory card while copying.
• Do not place any objects on the unit.
• Do not place the remote control on the
floor, etc., as buttons may be pressed by
mistake.
• Do not place the unit upright.
• Watch the screen in a bright room.
• Keep this unit away from children. If any
part of the unit is swallowed, promptly see
a doctor.
On power sources
The Media Storage is not disconnected from
the AC power source as long as it is
connected to the wall outlet, even if the unit
itself has been turned off.
Overheating
If the unit has become hotter than normal
during operation, turn off the unit,
disconnect the power cord, and contact a
service center.
Condensation
If the unit is brought from a cold to a warm
location, or if the ambient temperature
suddenly rises, moisture may form on the
outer surface and on the interior of the unit.
Do not use the unit in such a condition, as
damage may occur. If condensation has
occurred, leave the unit for about an hour
before turning it on.
