5-77
Chapter 5
Special Effects Operations
5
Special Effects
Operations
3
Adjust the parameters for the following items.
Stopping the ripple movement – F3 (LOCK)
Use the following procedure.
1
Press F3 (LOCK), turning it on.
This stops the ripples.
2
Turn the right knob to adjust the ripple phase.
• Right knob (“Ofst”): phase offset
Depending on the setting of F2(MODE), the range of this
parameter changes as follows;
“RADIAL”: –16 to +16
“ANGULAR”: –8 to +8
“BOTH”: –16 to +8
Selecting the form of the ripples – F7 (RIPPLE2 FORM)
Use the following procedure.
1
Press F7 (RIPPLE2 FORM), turning it on.
PLUS
ONLY
FORM
RADIAL
FORM
ANGULAR
130
RIPPLE2
RIPPLE FORM menu soft key indications
Item
Knob adjustments of parameters
Setting
“Mod
Radial”
Nature of the radial
modulation
Left (“Amp”): amplitude and direction
of the ripples (0 to 100%)
Center (“Freq”): degree of fineness of
the ripples (0 to 100%)
Right (“Sped”): direction and speed of
ripple motion (–100 to +100%)
“Mod
Angular”
Nature of the angular
modulation
Left (“Amp”): amplitude and direction
of the ripples (0 to 100%)
Center (“Freq”): degree of fineness of
the ripples (0 to 100%)
Right (“Sped”): direction and speed of
ripple motion (–100 to +100%)
“Position”
Position of the center
of the ripple pattern
Left (“X”): x-coordinate (–4 to +4)
Center (“Y”): y-coordinate (–3 to +3)
(Conti
nued)
