Functions of Parts and Controls
15
Functions of Parts and Controls
a
R TALLY lamp (red)
Lights when the red tally signal is input.
b
G TALLY lamp (green)
Lights when the green tally signal is input.
c
Up-tally lamp (red)
The supplied number plate can be attached to this.
Set TALLY ON/OFF switch to ON. The lamp lights in
the same way as the R TALLY lamp.
d
Tilt lock lever
Fixes any tilting position.
e
20-pin connector
Connect to a camera’s VF connector, using the supplied
connecting cable.
Power and video/tally signals are supplied through this
connector.
f
CONTRAST knob
1)
Adjusts the contrast of the viewfinder picture.
g
BRIGHT knob
1)
Adjusts the brightness of the viewfinder picture.
h
PEAKING switch and knob
1)
Adjusts the sharpness of the picture.
To make adjustments, set the PEAKING switch to either
LOW (low frequency peaking) or HIGH (high frequency
peaking). Select either LOW or HIGH, whichever is
easier for focusing the lens.
Then, use the PEAKING knob to sharpen the edges in the
picture. Turning the PEAKING knob clockwise adjusts
the sharpness of the edges in the picture.
When not adjusting, set the PEAKING switch to OFF.
i
(attention) indicator
This indicator lights up in orange when the camera detects
certain conditions. The particular conditions which cause
the indicator to light up are set up by the camera.
For information on how to set up and verify the
conditions under which the
indicator will light, refer to
the manual for the camera being used.
1)
These controls do not affect the output signal of the camera.
3
4
5
9
8
7
6
12
