21
Rear Panel
C
h
ap
te
r 2
N
a
m
e
s
a
n
d
F
u
nc
tion
s
of
P
a
rt
s
each unit. For editing using this unit and an HDCAM VTR,
connect the external equipment.
j
AUDIO MONITOR OUTPUT connectors (XLR
3-pin, male)
Output the audio signals of the channels selected with the
MONITR L and MONITR R on the P3 AUDIO page of the
function menu.
For details on the MONITR L and MONITR R settings, see
“3-7 Basic Operations of the Function Menu” on page 31.
k
AUDIO OUTPUT connectors (XLR 3-pin, male)
Output the analog audio signals of the channels selected
with setup menu item 824.
For details on setup menu item 824, see page 76.
l
AUDIO INPUT connectors (XLR 3-pin, female)
Input the analog audio signals.
m
HD SDI (high-definition serial digital interface)
OUTPUT connectors (BNC type)
Output the HD-SDI format video/audio signal. When
editing with two HDW-S280 units, connect a cable
between these connectors on the player VTR and the HD
SDI INPUT connectors on the recorder VTR.
You can superimpose timecodes, menu settings, error
messages, or other information on the output of these
connectors with the setting for CHARACTR on the HOME
page of the function menu or with the setting for setup
menu item 028. You can always disable to superimpose the
data independent of the setting for CHARACTR with the
setting for setup menu item 028.
For details on CHARACTR setting, see “3-7 Basic
Operations of the Function Menu” on page 31.
For details on the setup menu item 028, see page 64.
n
HD SDI (high-definition serial digital interface)
INPUT connectors (BNC type)
Input the HD-SDI format video/audio signal. When editing
with two HDW-S280 units, connect a cable between these
connectors on the recorder VTR and the HD SDI OUTPUT
connectors on the player VTR.
o
SDI OUT (serial digital interface output)
connectors (BNC type)
Output a D-1 format video/audio signal. The same signals
are output from the left and right connectors. You can
superimpose timecode, menu settings, or error messages
on the output of the 2(SUPER) connector when
CHARACTR on the HOME page of the function menu is
set to ON.
For details on CHARACTR setting, see “3-7 Basic
Operations of the Function Menu” on page 31.
p
COMPOSITE OUT (analog composite video
output) connectors (BNC type)
Output analog composite video signals. You can
superimpose timecodes, menu settings, or error messages
on the output of the 2 (SUPER) connector when
CHARACTR on the HOME page of the function menu is
set to ON.
For details on the CHARACTR setting, see “3-7 Basic
Operations of the Function Menu” on page 31.
