12
GB
Mounting the Bar
Speaker on a wall
You can mount the Bar Speaker on a
wall.
• Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely to two studs in the wall beam.
Install the Bar Speaker horizontally, hung
by screws in studs in a continuous flat
section of the wall.
• Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied) that
are suitable for the holes on the
rear of the Bar Speaker.
2
Fasten the screws to 2 studs in the
wall.
The screws should protrude by
8 mm to 9 mm (approx.
11
/
32
in).
3
Hang the Bar Speaker on the
screws.
Align the holes at the rear of the Bar
Speaker with the screws, then hang
the Bar Speaker on the two screws.
Notes
4 mm (
3
/
16
in)
More than 30 mm (1
3
/
16
in)
4.6 mm
(
3
/
16
in)
Hole on the rear of the Bar Speaker
9 mm
(
9
/
25
in)
560 mm
(22
1
/
20
in)
8 mm to
9 mm
(approx.
11
/
32
in)
