36
GB
You can connect to a
Bluetooth
device
from this receiver.
Check the following before playing music:
– The
Bluetooth
function of the
Bluetooth
device is turned on.
– The pairing has been completed
1
Place the
Bluetooth
device within
1 meter from this receiver.
2
Press BLUETOOTH
You can also use INPUT SELECTOR
on the receiver.
3
Perform connecting on the
Bluetooth
device.
For details, refer to the operating
instructions of your
Bluetooth
device.
4
Press
N
to start playback.
5
Adjust the volume.
Adjust the volume of the
Bluetooth
device first, if the volume level is still
too low, adjust the volume level on the
receiver.
To disconnect the
Bluetooth
device
Bluetooth
connection can only be
disconnected by the
Bluetooth
device or if
there is a signal loss.
To delete a paired
Bluetooth
device
from the device list
Initialize the receiver (page 49).
• Depending on the type of
Bluetooth
device, you
can adjust the volume using the controls of the
Bluetooth
device.
• If you cannot connect with a paired
Bluetooth
device, perform the pairing operation between
the receiver and the
Bluetooth
device again.
• If the input has been set to “BLUETOOTH”
when you turn on the receiver, the receiver
automatically connects to the last connected
Bluetooth
device.
To operate the
Bluetooth
device using the remote
control
Once the receiver and the
Bluetooth
device
are connected, you can control playback by
pressing
NX
*,
m
/
M
and
.
/
>
.
* If no
Bluetooth
device is connected and you
press
NX
, the receiver automatically
connects to the last connected
Bluetooth
device
and play back the music.
These operations may not be available for certain
Bluetooth
devices. In addition, the actual
operations may differ depending on the
connected
Bluetooth
device.
You can set the
Bluetooth
Standby mode so
that the receiver can be controlled by the
Bluetooth
device even when the receiver is
in standby mode.
1
Press BLUETOOTH.
You can also use INPUT SELECTOR
on the receiver.
2
Press AMP MENU.
3
Press
V
/
v
repeatedly to select
“BT”, then press
or
b
.
4
Press
V
/
v
repeatedly to select
“BT STANDBY”, then press
or
b
.
5
Press
V
/
v
repeatedly to select
“STBY ON”, then press
.
The receiver turns on automatically
when you establish the
Bluetooth
connection from the
Bluetooth
device.
Connecting a
Bluetooth
device
Notes
Note
Setting the
Bluetooth
Standby mode
.
/
>
m
/
M
NX
*