41
GB
“BRAVIA” Sync
Feat
ures
One-Touch Play
When you start playback the equipment
connected to the receiver via an HDMI
connection, the receiver and TV operation
are simplified as follows:
If you set “PASS THRU” to “ON” or
“AUTO” (page 47), then set the receiver to
standby mode, sound and image can be
output only from the TV.
• Be sure that the System Audio Control function
is set to on using TV menu.
• Depending on the TV, the start of the content
may not appear.
• Depending on the settings, the receiver may not
turns on when “PASS THRU” is set to “ON” or
“AUTO”.
You can also select a connected equipment, such
as Blu-ray Disc player or DVD player from the
TV menu. The receiver and TV will automatically
switch to the appropriate HDMI input.
System Audio Control
You can enjoy the TV sound from the
speakers connected to the receiver by a
simple operation.
You can operate System Audio Control
function using the TV menu. For details,
refer to the operating instructions of the
TV.
You can also use the System Audio Control
function as follows.
• If you turn on the receiver while the TV is
turned on, the System Audio Control
function will automatically activate to
output TV sound through the speakers
connected to the receiver. However, if
you turn off the receiver, the sound will
output from the TV speakers.
• When sound from the TV or other
equipment is output via the speakers
connected to the receiver, you can switch
the sound to output from the TV speakers
by pressing SPEAKERS TV
AUDIO.
• When you enjoy the TV sound from the
speakers connected to the receiver, you
can adjust the volume or turn off the
sound temporarily by using the TV’s
remote control.
Notes
Tip
Turns on (if in standby mode)
Switches to appropriate HDMI input
Receiver and TV
Switches the
TV speaker
setting to
output sound
from the
receiver
• Turns on (if in
standby mode)
• Switches to
appropriate
HDMI input
TV
Receiver
Turns off the TV
sound
temporarily
Outputs TV sound
