18
US
6
Hang the Bar Speaker on the
screws.
Align the holes of the rear of the Bar
Speaker with the screws, then hang
the Bar Speaker on the two screws.
7
Press and hold BASS for 5 seconds
to set the wall mount mode to on.
The USB indicator flashes twice.
You can optimize the sound of the
system that is mounted on a wall.
• When sticking WALL MOUNT TEMPLATE,
smooth it out fully.
• To set the wall mount mode to off, press
and hold BASS for 5 seconds. The USB
indicator flashes once.
When the TV Remote
Control does not Work
When the Bar Speaker obstructs the
remote control sensor of the TV, the TV
remote control may not work. In that
case, enable the IR repeater function of
the system.
You can control the TV with the TV
remote control by sending the remote
signal from the rear of the Bar Speaker.
Press and hold STANDARD for 5
seconds to set the function to on or
off.
• Be sure to check that the TV remote
control cannot control the TV, and then
set the IR repeater function to on. If it is
set to on when the remote control can
control the TV, appropriate operation
may not be obtained because of the
interference between the direct
command from the remote control and
the command via the Bar Speaker.
• On some TVs, this function may not work
correctly. In this case, place the Bar
Speaker slightly further away from the TV.
Notes
IR repeater on
The USB indicator flashes twice.
IR repeater off
The USB indicator flashes once.
Notes
Summary of Contents for HT-S200F
Page 41: ......
Page 87: ......
Page 132: ... 2018 Sony Corporation Printed in Malaysia 4 727 414 11 1 http www sony net ...
