13
GB
Make sure that any equipment connected is compatible with
“BRAVIA” Sync.
Check the Control for HDMI settings on the connected equipment.
Refer to the operating instructions supplied with the connected
equipment.
If you connect/disconnect the AC power cord (mains lead), wait for
more than 15 seconds and operate the system.
If you connect the audio output of the video equipment and the
system using a cable other than an HDMI cable, no sound may be
output because of “BRAVIA” Sync. In this case, set “CTRL” to “OFF”
(refer to “Adjusting the settings” in the Operating Instructions) or
connect the audio output jack directly to the TV instead of the
system.
“PRTECT (protect)” appears on the front panel display.
Press the
button to turn off the system. After “STBY”
disappears, disconnect the AC power cord (mains lead), then check
that nothing is blocking the ventilation holes of the system.
RESET
If the system still does not operate properly, reset the system as
follows:
1
Press the
button to turn on the subwoofer.
2
Press the
button while pressing INPUT and VOL
on the
subwoofer.
“RESET” appears and the system is reset. The menu, SOUND
MODE, etc., return to the default settings.
Specifications
Bar Speaker (SS-ST3)
Front L/Front R speakers
Speaker system
2-way speaker system, Passive radiator type
Speaker
Woofer: 30 mm × 100 mm cone type
Tweeter: 14 mm dome type
Passive radiator: 30 mm × 100 mm cone type
Rated impedance
3 ohms
Center speaker
Speaker system
2-way speaker system, Acoustic suspension type
Speaker
Woofer: 30 mm × 100 mm cone type × 2
Tweeter: 14 mm dome type
Rated impedance
3 ohms
General
Dimensions (approx.) (w/h/d)
900 mm × 40 mm × 32.5 mm (without stands)
900 mm × 42 mm × 30 mm (with stands)
Mass (approx.)
0.9 kg (with stands)
Subwoofer (SA-WST3)
Amplifier section
POWER OUTPUT (rated)
Front L + Front R: 15 W + 15 W (at 3 ohms, 1 kHz, 1 % THD)
POWER OUTPUT (reference)
Front L / Front R speaker: 25 W × 2 (per channel at 3 ohms, 1 kHz)
continued
