57
GB
U
s
in
g
th
e
V
a
ri
o
u
s
Fu
n
c
ti
o
n
s
/
S
e
tt
in
g
s
[IR-Repeater]
[On]: Remote signals for the TV are sent
from the rear of the main unit (page 49).
[Off]: Turns off the function.
For details, see “Sending the Remote
Signal to the TV via the Main Unit”
(page 49).
[HDMI Settings]
• [Control for HDMI] (page 49)
[On]: The Control for HDMI function is
enabled. Devices connected with an
HDMI cable can control each other.
[Off]: Off
• [Standby Linked to TV] (page 50)
This function is available when you set
[Control for HDMI] to [On].
[Auto]: If the input of the system is
[TV], [HDMI1], [HDMI2], or [HDMI3], the
system turns off automatically when
you turn off the TV.
[On]: The system turns off
automatically when you turn off the TV
regardless of the input.
[Off]: The system does not turn off
when you turn off the TV.
• [Standby Through] (page 51)
This function is available when you set
[Control for HDMI] to [On].
[Auto]: Signals are output from the
system’s
HDMI OUT (TV (eARC/ARC))
jack when the TV is turned on while
the system is not turned on. The
system standby power consumption
can be reduced more than when set to
[
On].
[
On]: Signals are always output from
the system’s
HDMI OUT (TV (eARC/
ARC)) jack when the system is not
turned on. If you connect a TV other
than those manufactured by Sony, we
recommend that you select this
setting.
[
Off]: Signals are not output from the
system’s
HDMI OUT (TV (eARC/ARC))
jack when the system is not turned on.
Turn on the system to enjoy on the TV
content of a device connected to the
system. The system standby power
consumption can be reduced more
than when set to [
On].
• [TV Audio Input Mode] (page 50)
Set this function when the system is
connected to a TV’s HDMI IN jack that
is compatible with eARC or ARC. The
eARC or ARC function is available
when you set [Control for HDMI] to
[On].
[Auto]: You can listen to TV sound
from the speakers of the system. The
sound of eARC or ARC takes priority
while set to [Auto].
[Optical]: Use this setting when an
optical digital cable is connected.
• [eARC]
Set this function when the system is
connected to a TV’s HDMI IN jack that
is compatible with eARC. When
connecting to a TV compatible with
ARC (not compatible with eARC), the
ARC function works regardless of this
setting.
[On]: Enables the eARC function. The
eARC function works when connecting
a TV compatible with eARC.
[Off]: Disables the eARC function.
When [eARC] is set to [On], make sure of
the eARC setting of the connected TV. For
details, refer to the operating instructions
of the TV.
• [HDMI Signal Format]
You can select the HDMI signal format
for the input signal. For details, see
“Setting the HDMI Signal Format to
Watch 4K Video Content” (page 17).
[Quick Start/Network Standby]
[On]: Shortens the startup time from
standby mode. You can operate the
system quickly after turning it on.
[Off]: Off
Note
Summary of Contents for HT-ST5000
