Other Functions
51
GB
Using an Adding Recording
At a factory setting, you cannot add a recording (page 34) not to erase the
message by accidental operation. If you want to add a recording to a
previously recorded message (page 34) or add an overwrite recording
(page 35), change the REC-OP setting in the procedures below.
1
Turn the jog lever toward MENU.
The menu mode will be displayed in
the display window.
2
Press the jog lever up or down
(
>/.
) to select “REC-OP”,
then press the jog lever (
x
•
B
).
The adding recording window will
be displayed.
3
Press the jog lever up or down
(
>/.
) to select “on”, then
press the jog lever (
x
•
B
).
The setting is changed.
4
Press the jog lever up or down
(
>/.
) to select “ADD” or
“OVER”, then press the jog lever
(
x
•
B
).
• ADD: adds a recording to a previously recorded message
• OVER: adds an overwrite recording
5
Press the jog lever toward MENU to exit the menu mode.
The normal display appears.
To prohibit to add a recording
In step 3 , select “OFF” and then press the jog lever (
x
•
B
).
Jog lever (
>/./x
•
B
/
MENU)
