ICD-SX68/SX68DR9/SX78/SX78DR9/SX88
10
[Test Mode]
The following checks can be implemented using the Test Mode.
How to Enter the Test Mode
• Turn the power on. (by inserting batteries)
• Turn ON the [V-UP] switch while pressing the [DIVIDE/
]
button and [VOL –] button at the same time.
How to Exit the Test Mode
Exit the test mode by turning OFF the power. (by removing the
batteries)
Initial Status of the Test Mode
When the machine enters the test mode, the LCD display appears
as shown below.
Select the desired item by using the [
>
]/[
.
] button, and
press the [
Nx
] button to set the selection.
1. Version
test
• Version of the respective modules are verifi ed.
• Press the [
x
] button to return to the test mode screen.
2. Key Chk + Format test
• Perform the key check by pressing the keys. The NAND for-
matting (deleting all events) and the default settings of the
menus (default language and LCD contrast remain unchanged)
are executed at the same time.
* [
Nx
]/[
>
]/[
.
]/[
/MENU]/[
z
]/[
x
]/[VOL +]/
[VOL –] /[ERASE]/[DIVIDE/
]/[
A-B/ ]/
[DPC (ON/OFF)]/[V-UP (ON/OFF)]/
[DIRECTNT (ON/OFF)]/[
.
HOLD]
• Press the [
x
] button to return to the test mode screen.
SECTION 3
TEST MODE
+
Loop
Version
Fmt
Loop
ExtMic Cal
SetMic Cal
Beep
Lcd Cont
RTC Int
Battery
BattAC2
BattAB4
BattCnt
Menu Init
Key Check
Log Output
App LogOut
Convert
VBUS
Sleep
START
Initial status of test mode
F/W version display
TEST MODE
END
TEST MODE
Turn off the power
(Remove the batteries)
ARM X.XX .XX
/
DSP X.X.XX
ICX-XXX
F/W version of
CPU(DSP block)
Boot:X
Oct XX 200X XX:XX:XX
F/W version of
CPU(ARM block)
F/W version of
Boot loader
liant
The checked key is display.
When all checks are
completed, the back-Light
turns on for 0.5 seconds
The NAND formatting
(deleting all events)
and the befault settings
of the menus are completed.
Total of 15 keys
*
are counted.
