– 31 –
FM SECTION
FM FREQUENCY COVERAGE Adjustment
BAND : FM
VOLUME control : as required
Connection Points :
Procedure :
1. Tune the set to 76MHz.
2. Adjust T201 to obtain a 1.6V on the digital voltmeter.
Standard value : 1.55 – 1.65V
3. Tune the set to 108MHz.
4. Make sure that the digital voltmeter reading is below 11V.
Adjustments Location : MAIN board (see page 33)
FM TRACKING Adjustment
Note :
This adjustment should be performed after the remove Rod
Antenna (ANT102).
This adjustment should be performed after the FM FRE-
QUENCY COVERAGE ADJUSTMENT.
BAND : FM
VOLUME control : as required
Connection Points :
Procedure :
1. Set the frequencies of the FM RF SSG and the frequency dis-
play of the set to 76MHz.
2. Adjust T106 and T107 to obtain a maximum reading on the level
meter.
3. Set the frequencies of the FM RF SSG and the frequency dis-
play of the set to 108MHz.
4. Adjust CT101 and CT102 to obtain a maximum reading on the
level meter.
5. Repeat the above steps several times, and finish the adjustment
with the trimmers CT101 and CT102.
Adjustments Location : MAIN board (see page 33)
FM RF SSG
0.01uF
TP(ANT)
22.5kHz frequency
deviation by 400Hz signal.
Output level :
as low as possible
[ MAIN BOARD]
(Side A)
J302(headphone)
level meter
16
Ω
set
Digital
Voltmeter
TP (VT)
[ MAIN BOARD] (Side A)
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
