Clean the flash surface before use. The heat of the flash emission may cause dirt on the flash
surface to start smoking or burning. Wipe the flash surface with a soft cloth to remove dirt or
dust, etc.
Cleaning the camera body
Do not touch the parts of the product inside the lens mount, such as a lens signal contact. To
clean inside the lens mount, use a commercially available blower* to blow any dust off.
*
Do not use a spray-type blower as doing so may cause a malfunction.
Cleaning the product surface
Clean the product surface with a soft cloth slightly moistened with water, then wipe the surface
with a dry cloth. To prevent damage to the finish or casing:
Do not expose the product to chemical products such as thinner, benzine, alcohol,
disposable cloths, insect repellent, sunscreen or insecticide.
Do not touch the product with any of the above on your hand.
Do not leave the product in contact with rubber or vinyl for a long time.
Cleaning the monitor
If oil from your hand or hand cream, etc., remain on the monitor, the original coating may
become easily removable. Wipe oil or hand cream off as soon as possible.
If you wipe the monitor firmly using tissue paper, etc., the coating may be scratched.
If the monitor becomes dirty with fingerprints or dust, gently remove the dust from the
surface, and then clean the monitor using soft cloth, etc.
How to Use
Precautions/This product
Cleaning this product
Cleaning the image sensor
Follow the steps below to clean the image sensor.
1. Turn off the product.
2. Remove the lens.
3. Blow off dust on and around the image sensor surface using a blower for camera cleaning.
4. Attach the lens.
Note
