97
Configuring Action Settings
C
h
ap
te
r 4
A
pplic
at
io
n
S
e
tti
n
gs
[System Action] Tab
Screen example: For servers
Send e-mail
Select the check box to send a notification by mail to a
specified mail address.
E-mail Address
Enter an e-mail address.
Attach Camera Image
Select the check box to send a still image as a mail
attachment.
If you select this, specify the camera for recording the
still image.
Images will not be attached for cameras on which the
codec is MPEG4/H.264 or for cameras on which
masks are configured.
Specified Camera
Record a still image with the specified camera.
Message
Enter the message of the mail. It can be up to 32
characters long.
Change Layout
Select the check box to change the monitor layout of
monitor 1.
If you select this, select the monitor layout to display
on monitor 1.
This item is only displayed for a server.
Beep
Select the check box to play a beep tone.
If you select this, select a beep tone type.
This item is only displayed for a server.
You must configure an action to stop the beep tone.
Pre-define an action for stopping the beep that is
triggered by a manual or sensor input event.
Apply
This saves the settings.
Cancel
This cancels the changes to the settings.
Event/Alarm Actions
An action is performed if an alarm or event occurs within
the duration set for a schedule. An action can be performed
each time an alarm or event occurs, provided it occurs
within the duration.
Even if the state changes as a result of an action being
performing, the original state is not restored automatically.
Event/Alarm Action Example:
When an event/alarm action for moving the preset position
to “Preset 2” if motion is detected by the VMD (camera)
pin of camera 1:
1
When the VMD (camera) pin detects motion, the
action is performed and the preset position of camera
1 moves to “Preset 2.”
2
The preset position is returned to “Preset 1” manually.
3
When the VMD (camera) pin detects motion within
the duration, the action is performed again and the
preset position of camera 1 moves to “Preset 2.”
Registering an Event/Alarm Action
Configure a schedule for performing an action when an
alarm or event occurs within the duration set for the
schedule. An action can be performed each time an alarm
or event occurs, provided it occurs within the duration.
1
Click [Schedule] at the top of the Configuration
window.
The Schedule Configuration screen appears.
2
Switch to recurrent view or date view.
Note
Note
Caution
0
12
24
Preset 2
Preset 2
Preset 1
Preset 2
Alarm Recording Schedule
Summary of Contents for Ipela NSR-1050H
Page 138: ......
