71
Registering Local Information
Cha
p
te
r
2:
Re
gis
trat
io
n
and Se
tu
p
fo
r Sys
tem Admin
ist
rat
o
rs
Gatekeeper Mode
Allows you to select whether to use the
gatekeeper to control access to a LAN.
Using the gatekeeper allows you to dial
using the user name or user number as well
as dialing using the IP address.
Auto:
Automatically detects the gatekeeper
and uses it.
On:
Enables the gatekeeper.
Off:
Disables the gatekeeper.
Gatekeeper Address
Enter the address of the gatekeeper used
when “Gatekeeper Mode” is set to “On”.
User Alias
Enter the user name (H.323 alias) registered
in the gatekeeper.
User Number
Enter the user number (E.164 number)
registered in the gatekeeper.
Used Port
Number, RTP/RTCP Setup
Q.931
Enter the Q.931 port number.
H.245
Enter the H.245 port number.
RTP/RTCP
Enter the RTP/RTCP port number.
MTU Size
Enter the MTU size.
SNMP
SNMP Mode
Allows you to select whether the Simple
Network Management Protocol (SNMP)
agent is enabled.
On:
Enables the SNMP agent.
Off:
Disables the SNMP agent.
Trap Destination
Enter the address of the trap destination
SNMP manager.
Community
Enter the community name managed by the
SNMP manager (up to 24 characters). By
default, “public” is entered.
Description
Enter the description of this terminal. By
default, “Videoconference Device” is
entered and can not be changed.
Location
Enter the location where this terminal is
installed (up to 30 characters).
Contact
Enter information about the terminal
administrator (up to 30 characters).
Specifies the functions for providing
optimum consistent communication.
• When “Lip Sync” is set to “Off” in the Audio
setup menu, you cannot change the setting
for “Adaptive Rate Control (ARC)”, “Packet
Resend Request (ARQ)” or “Forward Error
Correction (FEC)”.
• When “Adaptive Rate Control (ARC)”,
“Packet Resend Request (ARQ)” or
“Forward Error Correction (FEC)” is set to
“On”, you cannot set “Lip Sync” to “Off” in
the Audio setup menu.
Basic Setup
Adaptive Rate Control (ARC)
Allows you to select whether to always
optimize the LAN bandwidth.
On:
Always optimizes the LAN bandwidth.
Off:
Does not optimize the LAN bandwidth.
Auto Bandwidth Detection
Allows you to select whether you use the
Auto Bandwidth Detection feature.
On:
Enables the Auto Bandwidth Detection
feature
.
Off:
Disables the Auto Bandwidth Detection
feature.
LAN
LAN
QoS Setup Menu
Notes
QoS1
Summary of Contents for Ipela PCS-G60
Page 253: ...Sony Corporation ...
