139
Starting a Multipoint Connection
C
h
apt
er
6:
M
u
lti
p
o
int
C
o
nn
ect
ion
When the system connects to all the remote parties, the message “Session
Connected” appears on the screen, and the ON LINE indicator stops blinking
and lights in blue.
You can set “Total Bandwidth” (Communication Bit Rate of total points) in the
Communication Mode menu in this unit.
The actual Communication Bit Rate may not be the value set in the List Edit menu
because the Communication Bit Rate on each point is automatically adjusted so that
the total bit rate of all points does not exceed “Total Bandwidth” in Multipoint
connection.
To call additional remote parties
After communication begins with the first party, press the MENU button on
the Remote Controller to open the launcher menu.
Perform one of the procedures described in “Calling a Remote Party” on page
81.
If some points are not connected
The following dialog appears. Select the desired item.
Start Connection:
Starts a communication with remote parties connected.
Disconnect All:
Cancels all the connections and restores the launcher menu.
Redial:
Redials the numbers of the points that you failed to connect.
Note
Capture
Room 10A
Room 11B
Room 12A
Room 01
IP:255.255.255.255
2005.12.28 12:34
Menu
Phone Book
Detailed Dial
History
Enter the remote party number.
Dial
Some positions were not connected.
Redial
Disconnect All
Start Connection
