175
On-screen Messages
Ap
pe
ndi
x
The following messages indicate the state of the system. No action is required.
Could not start connection because the
encryption feature of the remote system was
disabled.
Have the far-end side enable their encryption
feature, then start the connection again.
The remote party refuses the network quality
measurement.
Network quality measurement has failed as
“Measurement from Remote Site” in the
Administrator Setup menu is set to “Disabled” on
the remote terminal.
The remote party is in communication.
Network quality measurement has failed as the
remote party is conducting a communication.
The remote part is starting or shutting down
the system.
Network quality measurement has failed as the
remote party is starting or shutting down the
system.
The network quality measurement is running
on the remote site.
Network quality measurement has failed as the
remote party is performing the network quality
measurement.
The network quality measurement cannot be
performed because the LAN cable is
disconnected.
Check the LAN cable connection.
The network quality measurement cannot be
performed because the IP address is 0.0.0.0.
Set “IP Address of Remote Site” correctly on
“Network Quality Measurement (Page 1/4)” of the
Administrator Setup menu.
The network quality measurement cannot be
performed during communication.
Try to perform the network quality measurement
after the communication has finished.
The network quality measurement cannot be
performed because the system is starting or
shutting down.
The network quality measurement cannot be
performed when the local system is starting or
shutting down.
The network quality measurement is being
run by the remote party.
Please wait.
Try to start the network quality measurement after
the measurement on the remote terminal has
finished.
No more dialing is possible as multipoint
connection is disabled in Communication
setting.
Set “Multipoint Connection” to “Enable” on Page
1/2 of the Communication Mode menu.
The network quality measurement has
failed.
Check the network connection.
Disconnected because reception of packets
from the far-end side has stopped.
Packets were not received properly.
Message
Meaning
Session Connected
Connection with the remote party has been completed, and
you can now start a connection.
Starting connection.
After receiving a call from the remote party the system starts
connection.
Message
Meaning
