91
Ending the communication
C
h
a
p
te
r 3:
B
a
si
c
C
o
nn
ect
ion
Ending the communication
1
Press the CONNECT/DISCONNECT (
/
) button on the Remote
Commander.
The message “Disconnect?” appears on the monitor screen.
2
Press the
B
or
b
button on the Remote Commander to select “OK”, then
press the PUSH ENTER button, or press the CONNECT/DISCONNECT
(
/
) button on the Remote Commander again.
The system is disconnected.
The power of the Communication Terminal remains on even if the system is
disconnected.
To cancel disconnection of the system
Select “Cancel” with the
B
or
b
button, then press the PUSH ENTER button.
To register the connected remote party in the Phone Book
You can easily register the remote party who has just disconnected.
If you set “Last Number Registration” in the General Setup menu to “On”, the
message “Register this participant in the list?” appears after a communication
with an unregistered remote party is finished. When you select “OK”, the List
Edit menu appears.
If the “Last Number Registration” is set to “Off”, the message does not appear.
For “Last Number Registration” setting,“Device Setup” page of the General
Setup menu on page 47.
Note
Note
