200
Using the Display Control
Using the Display Control
During a multipoint connection you can control the following operations.
There are four broadcast modes, “Split” and “Voice Activate”, and “Split
(fixed)” and the broadcast select mode.
You can set up “Split” and “Voice Activate” modes in “Broadcast Mode” of
the Multipoint setup menu.
You can select “Split (fixed)” and broadcast select modes in the Layout menu
during communication.
Split mode
This mode allows display of the pictures of the connected remote terminals and
the picture of the local terminal by splitting the monitor screen.
You can select “Six-screen Mosaic” or “Automatic” in “Split” of the
Multipoint setup menu. When “Six-screen Mosaic” is selected, the display is
split into six regardless of the number of terminals. When “Automatic” is
selected, the display is automatically split into four if two or three terminals are
connected or into six when four or five terminals are connected.
The split windows A to C or A to E display the pictures of the remote terminals
in the connected sequence.
• When the six-split window is displayed, the system detects the terminal including the
loudest voice among all the terminals and displays the picture of that terminal in the
lower right window. The picture on the local terminal is then displayed in the window
where the picture of the detected terminal was displayed.
Broadcast Mode
Notes
Four-split window
Six-split window
Picture A
Picture B
Picture on the
local terminal
Picture C
Picture A
Picture B
Picture C
Picture D
Picture E
Picture on the
local terminal
Summary of Contents for Ipela PCS-XG80
Page 266: ...Sony Corporation ...
