233
Troubleshooting
Ap
pe
ndi
x
Troubleshooting
If the Communication System does not function correctly, check the following.
Symptom
Cause
Solution
The power is not
turned on.
The power switch is not set to on.
Press the power switch to turn on the
power of the system (page 40).
The batteries in the Remote
Commander are low or dead.
Replace the batteries with new ones
(page 36).
The Remote
Commander does
not operate.
It is isolated from the
communication system.
Perform pairing of the Remote
Commander with the Camera (page
37).
Pairing with the Remote
Commander fails.
Perform pairing of the Remote
Commander with the System or
Camera Unit (page 37).
No sound or the
volume is very low.
The volume of the system is too
low.
Adjust the sound volume by pressing
the /– buttons on the
Remote Commander (page 43).
The volume of the TV monitor is
too low.
Adjust the volume of the TV monitor.
The microphone on the remote
party is turned off.
Ask the remote party to turn on the
microphone.
Audio input is not selected
properly.
• Set up “Input Select (MIC)” on the
Basic Setup1 page of the Audio
setup menu properly (page 70).
• Set up “Audio Input” properly on
the Basic Setup1 page of the Audio
setup menu (page 70).
The microphone or external
equipment is not connected
correctly.
Check the connection (pages 164, 167
and 172).
Picture is blurred.
Manual focus is selected but picture
remains blurred.
Adjust the focus (page 140).
When auto focus is selected, the
background is too bright, contrast is
too high, or the background or the
participants’ clothes contain fine
line patterns.
Select manual focus and adjust
manually (page 140).
Summary of Contents for Ipela PCS-XG80
Page 266: ...Sony Corporation ...
