37
Preparing the System
C
h
apt
er
1:
In
st
al
la
tio
n
and
Pr
e
par
at
io
n
• If battery leakage occurs, clean the battery compartment and replace all the
batteries with new ones.
The supplied Remote Commander controls the HD Visual Communication
System using the radio frequency of 2.4 GHz. The Remote Commander and
the Communication System are paired to prevent interference from other
Remote Commanders and Systems.
Pairing between the Remote Commander and the Communication System is
programmed at the factory. If the Communication System is installed in
shielded locations, such as under a desk or in a rack, it may not be controlled
by the Remote Commander, depending on the conditions of radio-wave
reception. In this case, pair the PCSA-CXG80 HD Camera Unit with the
Remote Commander.
When performing pairing procedure, be sure to turn off other HD Visual
Communication Systems or HD Camera Units located nearby that are not targets for
pairing. If multiple devices are turned on, the Remote Commander might pair device
other than the target one.
To pair the Camera Unit with the Remote Commander
1
Press the
?
/
1
(power) switch on the Communication System to turn it on.
The
?
/
1
(power) indicator on the Communication System flashes. The
indicator lights in green when the Communication System turns on.
2
Set “RF Remote Control Reception” to “Camera” in the General setup
menu.
Programming the Remote Commander to Operate the Camera Unit
Note
/
F1
F2
F3
F4
T
W
1
2
3
4
5
6
7
8
9
0
/
GHI
JKL
MNO
PQRS
TUV
WXYZ
ABC
DEF
PRESENTATION
LAYOUT
RETURN
CONNECT
ON/OFF
MIC
BACK
SPACE DISCONNECT
TONE
DOT
TOOLS
VOLUME
ZOOM
VIDEO INPUT CAMERA
ENTER
OPEN
/
POWER/STANDBY
1
?
/
1
(power) indicator
LED indicator
4
3
Summary of Contents for Ipela PCS-XG80
Page 266: ...Sony Corporation ...
