88
Registering Local Information
Image Flip for Second Camera
Allows you to select whether to rotate the
camera image 180 degrees when the second
camera is installed on a ceiling.
Flip Vertical:
Rotates the image 180
degrees.
Off:
Does not rotate the image 180 degrees.
• The “Image Flip” function will be enabled
after system rebooting.
• The “Image Flip” function cannot be used
with the PCSA-CXG80 HD Camera Unit.
Other
Use History
Select whether to display the history lists in
order to use for dialing, etc.
On:
Displays the history lists.
Off:
Does not display the history lists.
Save Setup
Saves the data for each setting to a “Memory
Stick”. The data for each setting saved on the
“Memory Stick” is overwritten.
Phone Book and History data are not saved.
Load Setup
Loads the data for each setting from a
“Memory Stick”. The data for each setting
saved on the System is overwritten.
When saving and loading settings, make sure
that the version of the system from which the
data was originally saved is the same as the
version of the local system. If the versions
differ, the data may not be properly recognized.
AMX Device Discovery
Select whether to export AMX Device
Discovery information onto the network.
Off:
Disables this function.
On:
Enables this function.
When the AMX system is connected to the
Communication System via serial
connection, AMX Device Discovery
information is output via that serial
connection.
AMX systems are external control devices
that can be used to control the
Communication System. When the AMX
system receives Device Discovery
information from the Communication
System, the System automatically falls
under the control of the AMX system.
HOP
Enter a number from 0 to 255 as the HOP
Display Terminal Name.
1080i Mode
Allows you to select whether to transmit or
receive the picture in 1080i mode.
Transmission and reception of the picture in
1080i mode is available only for connection
via LAN.
You can connect to a remote party in 1080i
mode only by using the button in the Home
menu.
Off:
Does not use 1080i video format.
On:
Uses 1080i video format. When set to
“On”, the system reboots automatically.
• The 1080i Mode is not available for S video
or RGB input signal.
• When “1080i Mode” is set to “On”, a remote
party must enable communication in 1080i
video format.
• When “1080i Mode” is set to “On”,
presentation and PinP, PandP and Side by
Side displays are not available.
• When “1080i Mode” is set to “On”, the
Annotation function is not available.
• When “1080i Mode” is set to “On”, the Web
Access function is not available even if
“Web Access” is set to “Enabled” in the
Administrator setup menu.
Auto Restore
Allows you to select whether to
automatically turn on the Communication
System if an power interruption occurs and
is then restored.
On:
Enables the Auto Restore function.
Off:
Disables the Auto Restore function.
Internet Protocol
IPv4:
Uses the internet protocol version 4
(IPv4) that is commonly used.
Notes
Note
Note
Administrator7
Notes
Summary of Contents for Ipela PCS-XG80
Page 266: ...Sony Corporation ...
