174
Viewing the Picture from the System on a Monitor or Projector
Viewing the Picture from the System on
a Monitor or Projector
When the monitor or projector is connected to the Communication System,
you can view the picture from the system.
To connect a monitor or projector
To use the connected display equipment
When outputting the picture both to the monitor connected to the HDMI OUT
connector and the display equipment connected to the RGB OUT connector,
set “Monitor Output” to “HDMI+RGB” on the Basic Setup page of the Video
setup menu (page 72).
For RGB output, you can select the video format of the signal output from the
RGB OUT connector with “RGB Monitor Output Format”. You can select
“SXGA”, “XGA” or “WXGA” (page 72).
• The HDMI output is available only when the output signal is of 1080i video format.
• If “Monitor Output” is set to “HDMI+RGB” when no HDMI monitor is connected to
the Communication System, you cannot view the menus. Before making this setting,
be sure to connect an HDMI monitor.
Notes
TERMINAL
VISCA OUT
1
1(R)
(PLUG IN POWER)
2(L)
R
L
R
L
R
L
2
S VIDEO IN
RGB IN
RGB OUT
HDMI OUT
1-EXT-2
REC OUT
AUDIO OUT
AUDIO 1 IN
AUX CONTROL
2
CAMERA
EC-MIC(A7)
MIC(A1/A3)
1
DC 19.5V
ISDN UNIT
to RGB
OUT
to HDMI OUT
Connecting cable with D-sub 15-pin
connectors
Monitor,
projector, etc.
Monitor
to HDMI IN
HDMI cable
(supplied)
to RGB IN
Summary of Contents for Ipela PCS-XG80
Page 266: ...Sony Corporation ...
