224
Location and Function of Parts and Controls
This Camera Unit is not supplied with
PCS-XG80S.
a
Lens
This is a 10-magnification optical zoom
lens.
b
POWER/STANDBY indicator
Lights in green when the System is
turned on. When the System is set to
standby mode or is turned off, it lights in
orange.
c
TERMINAL connector
Connect to the CAMERA connector on
the System.
d
Receiver of the RF Remote
Commander
Point the supplied RF Remote
Commander at this receiver when
pairing with the Camera Unit.
e
VISCA OUT connector
Used for VISCA communications.
When a second camera is connected to
the System, connect to the VISCA IN
connector on the second camera.
f
Tripod attachment screw hole
Use to attach the camera to a tripod.
For details on the tripod screw, see
“Attaching the PCSA-CXG80 HD
Camera Unit to a Tripod” on page 35.
g
Fixing screw holes
Use to fix the camera to a fitting.
h
Attachment locations for
hook-and-loop pads
When you use the supplied
hook-and-loop pads, stick them to these
locations.
PCSA-CXG80 HD Camera
Unit (Supplied with
PCS-XG80)
Note
POWER/STANDBY
1
2
TERMINAL
VISCA OUT
3
4
5
6
7
8
Front
Rear
Bottom
Summary of Contents for Ipela PCS-XG80
Page 266: ...Sony Corporation ...
