42
Turning the System On/Off
1
Display the Home menu on the monitor screen, then press the
@
/
1
button
on the Remote Commander.
The message “Power off?” appears on the monitor screen.
2
Press the
V
,
v
,
B
or
b
button on the Remote Commander to select OK, then
press the ENTER button.
You may press the
@
/
1
button on the Remote Commander.
The Communication System enters standby mode and the
@
/
1
indicator on
the Communication System lights in orange.
To cancel setting the system to standby
Select “Cancel” with the
V
,
v
,
B
or
b
button on the Remote Commander, then
press the ENTER button in step 2 above.
To release the standby mode
Press any button on the Remote Commander.
To specify the standby time
Specify the time that you want the system to remain on before entering into
standby mode (1 to 99 minutes) by setting “Standby Time” of the Device Setup
page of the General setup menu. If you do not want the system to enter the
standby mode, set “Standby Mode” to “Off”.
For the settings, see “Standby Time” and “Standby Mode” in the General
setup menu on page 81.
1
Press the
@
/
1
(power) switch on the Communication System.
The message “Power off?” appears on the monitor screen.
2
Press the
V
,
v
,
B
or
b
button on the Remote Commander to select “Power
off”, and press the ENTER button.
You can power off the system by pressing the
@
/
1
(power) button on the
Remote Commander.
The system turns off.
3
Turn off the power of other equipment used for the communication.
• Turn off the power switch on the Communication System when the system will not
be used for an extended period. While the power switch is off, you cannot receive a
call from a remote party.
Setting the HD Visual Communication System to Standby Mode
Turning Off
Notes
Summary of Contents for Ipela PCS-XG80
Page 266: ...Sony Corporation ...
