78
Registering Local Information
Audio:
Configure the TOS field for audio
data.
Data:
Configure the TOS field for camera
control signals, etc.
Presentation:
Configure the TOS field for
the RGB presentation data.
TOS
Allows you to select how to define the TOS
(Type of Service) field of the data selected in
“TOS Data Type”.
Off:
Does not define the TOS field.
IP Precedence:
Defines the TOS field as IP
Precedence.
DSCP:
Defines the TOS field as the
Differentiated Services Code Point
(DSCP). Enter the value between 0 and
63.
Precedence
Enter the IP Precedence value between 0 and
7.
Low Delay
Allows you to select whether to specify the
Low Delay bit of the TOS field.
On:
Specifies the Low Delay bit of the TOS
field.
Off:
Does not specify the Low Delay bit of
the TOS field.
High Throughput
Allows you to select whether to specify the
High Throughput bit of the TOS field.
On:
Specifies the High Throughput bit of
the TOS field.
Off:
Does not specify the High Throughput
bit of the TOS field.
High Reliability
Allows you to select whether to specify the
High Reliability bit of the TOS field.
On:
Specifies the High Reliability bit of the
TOS field.
Off:
Does not specify the High Reliability
bit of the TOS field.
Minimum Cost
Allows you to select whether to specify the
Minimum Cost bit of the TOS field.
On:
Specifies the Minimum Cost bit of the
TOS field.
Off:
Does not specify the Minimum Cost bit
of the TOS field.
DSCP
Enter the DSCP value. This item only
appears when “TOS” is set to “DSCP”.
The SIP setup menu is used to connect with
an IP phone, etc. using the SIP (Session
Initiation Protocol).
Basic Setup
SIP Server Mode
Allows you to select whether you use a SIP
server or not.
On:
Enables use of the SIP server.
Off:
Disables use of the SIP server.
Transport Protocol
Allows you to select the protocol to be used
for SIP.
TCP:
Uses TCP (Transmission Control
Protocol).
UDP:
Uses UDP (User Datagram Protocol).
This is the factory default setting.
Port Number
Enter the port number to be used for SIP.
SIP Domain
Enter the SIP domain name.
Registered User Name
Enter the user name for the terminal to be
registered to the SIP server (up to 39
characters).
Password
Set the password for the terminal to be
registered to the SIP server (up to 39
characters).
SIP Server Address
Enter the address of the SIP server.
SIP Server Port
Enter the port number used for
communication with the SIP server.
SIP Setup Menu
SIP
Summary of Contents for Ipela PCS-XG80
Page 266: ...Sony Corporation ...
