- 20 -
1.
Receive a television broadcast signal.
2.
Normalize the picture setting.
3.
Adjust the focus control located on the flyback transformer
to obtain the best focus at the centre of the screen.
Bring only the centre area of the screen into focus, the
magenta-ring appears on the screen. In this case, adjust the
focus to optimize the screen uniformly.
3-4. Screen (G2), White Balance
[Adjustment in the service mode using the remote
commander]
G2 adjustment
Layout of each control
White balance adjustment for TV mode
V.STAT
BMC (Hexapole)
Purity
3-3. Focus Adjustment
Screen
Focus
1.
Input a dot signal from the pattern generator.
2.
Set the Picture, Brightness and Colour to minimum.
3.
Apply 165V DC from an external power supply to the R, G
and B cathodes of the CRT.
4.
Whilst watching the picture, adjust the G2 control [SCREEN]
located on the flyback transformer to the point just before the
flyback return lines disappear.
1.
Input an all-white signal from the pattern generator.
2.
Set the TV set or operation in Service Mode.
[ See Page 21 ].
3.
Select ‘Service’ from the on screen menu display and press
‘Right Arrow’.
4.
The ‘Service’ menu will appear on the screen.[See Page 21]
5.
Set the ‘Subcont’ to MAX.
6.
Set the ‘R-Drive’ to 50.
7.
Adjust the ‘G-Drive’ and the ‘B-Drive’ so that the white
balance becomes optimum.
8.
Press the ‘OK’ button to write the data for each item.
9.
Set the ‘Subcont’ to MIN.
10. Adjust the ‘Cutoff Br.’ with the left and right buttons on the
remote commander so that the white balance becomes optimum.
11. Press the ‘OK’ button to write the data.
